![]() Apply painter's tape to bottom of largest piece (words). Cut out of adhesive vinyl with a Cricut or another cutting machine. I tend to use the “fatigue method” where I apply the transfer tape, remove the paper backing, hold it above the surface and eyeball it to get the right placement and then hold it until the vinyl accidentally touches the surface or my hands give up and drop it in place. Download free cut file (in post) and upload to Cricut Design Space. You can use dry erase markers, a level, a water line (if putting on a glass)… There are other tricks too depending on what you are applying the vinyl to. Peel off the transfer tape slowly, squeegeeing more if necessary. /rebates/2fen-us2fmaterials2fmaterial-type2fvinyl&252fen-us252fmaterials252fmaterial-type252fvinyl26tc3dbing-&idcricut&nameCricut&ra4. Squeegee the design from the center out to push any excess water out, dabbing with a paper towel to absorb the water. You should be able to move it around a bit to be sure it is straight. You add a few drops of baby shampoo to about 8 oz water in a spray bottle.Īpply your design using paper transfer tape (paper transfer tape works better than plastic transfer tape for the set method). Using the “wet method” helps too because you can adjust the design on your surface before it is completely adhered. If you don’t have any rubbing alcohol then simply give it a good hot wash. If you are applying this to a curved surface, the “hinge” can be on the side instead of the top of your design. Prepare your mug Prepare your curved surface by wiping it with rubbing alcohol, and allowing it to dry completely. OPTION 1: WHITE ADHESIVE VINYL ON A GLASS CUTTING BOARD. Smooth the transfer tape (with the design under it) down onto your surface with a plastic card or scraper. Clear Laminating Pouches if you don’t want to use vinyl Cricut Spatula to remove the rubber feet under the cutting board Scissors Pen or pencil Or, you can use sublimation-ready blanks, like. Lift the bottom of your design up (like a hinge), holding the transfer tape in place if needed, and peel off the paper backing, leaving the vinyl design stuck to the transfer tape. For use with all Cricut cutting machines. Press down the adhesive part of the transfer tape area to your surface. Water-resistant Permanent Premium Vinyl works wonders on glassware and is highly recommended for indoor decor. Leaving the paper backing on your design, place the design where you would like. Put the transfer tape on the design so the exposed part of the transfer tape is above the design and backing and smooth it into the design with a scraper. Trim your transfer tape on your cut design to 3.5x5.5 roughly.Ĭut your transfer tape so it is taller than your design. Don’t press it all just lay it down and then you can hold it up to make sure it’s even and. Once you’ve removed the transfer paper backing, take your wine glass and just lay your vinyl onto the glass. One way for example, let’s say your cut design is 3”x5”. We’ll share our best Cricut hacks for working with vinyl on wine glasses so you can make a beautiful gift for someone special. ![]() Try the “hinge method” there are YouTube videos on how to do it and there are a couple of ways. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |